Thermiq NeoLink 3 F820 69 | HERZ Thermiq

Thermiq NeoLink
3 F820 69

Thermiq NeoLink is a wireless radio relay kit (230 V AC, 868 MHz) designed for transferring switching signals and for the wireless control of electrical devices in heating, cooling, and automation systems. The set consists of a factory-paired transmitter (TX) and receiver (RX), allowing for an easy installation in buildings without previously installed wiring. Thanks to a built-in supercapacitor, the transmitter reliably sends an "OFF" command to the receiver in the event of a power outage, while the wireless range also supports an optional 3-minute power-on delay. Featuring extremely compact dimensions for both units, it is suitable for flush-mounted installation in junction boxes or for mounting on a standard DIN rail using the included brackets.

Drawing

Category:

HERZ Thermiq

IDENT	EAN	CONNECTIVITY	POWER SUPPLY	L	H	L1
3 F820 69	3838963250616	Wired	230V AC, 50 Hz	46	46	24

The Thermiq NeoLink wireless radio relay module is an ideal solution for renovations, upgrades, and buildings where no wiring is provided between the control unit and the load, or where individual conductors are missing.

Benefits of use:

Wireless connection between thermostat and wiring centre: Transmission of the 230 V control signal from the zone thermostat to the underfloor heating control box without laying cables.
Control of the heat source (boiler / heat pump): Wireless transmission of a volt-free switching signal from the wiring centre or thermostat to the boiler or heat pump.
Circulation pump management: Wireless ON/OFF switching of the circulation pump via a light switch or an output from the control box.
Control of other electrical loads: Suitable for wireless control of electric heaters, fans, lighting, and other appliances with a load capacity of up to 16 A.

EC Declaration of Conformity

By affixing the CE marking, the manufacturer declares that HERZ Thermiq complies with the following relevant safety regulations:

EU Low Voltage Directive 2014/35/EU
EU Electromagnetic Compatibility Directive 2014/30/EU
EU RoHS Directive 2011/65/EU
EU WEEE Directive 2012/19/EU (Reg. No. DE 23479719)

Conformity has been verified, and the relevant documentation as well as the EU Declaration of Conformity are retained by the manufacturer.

Declaration of Conformity - SLO, ENG, DEU

Parameter	Value
Power Supply	230 V AC
Total Maximum Load	16 A
Communication	Wireless, radio 868 MHz
Outputs	Volt-free contact (NO/COM)
Power-on Delay	Optional 3-minute delay
Dimensions [mm]	46 x 46 x 24

The diagram shows the connection terminals and control elements of the transmitter and receiver.

Power supply 230 V AC
Volt-free output
Function button
LED indicating the status of the device

Installation

Installation Rules:
Installation must be carried out by a qualified person with appropriate electrical qualifications in accordance with applicable regulations and standards. The devices are intended for use in dry indoor spaces.

Wiring Diagram Options:

SOLUTION FOR SITUATIONS WHERE WIRES ARE NOT AVAILABLE

SOLUTION WHEN WIRES BETWEEN THE THERMOSTAT AND THE WIRED CONTROL BOX ARE NOT AVAILABLE

WIRELESS SWITCHING OF THE CIRCULATION PUMP VIA A LIGHT SWITCH

SOLUTION FOR THE PROBLEM OF 1 MISSING WIRE BETWEEN THE THERMOSTAT AND THE CONTROL BOX

WIRELESS CONNECTION OF THE CONTROL BOX AND THE CIRCULATION PUMP

- WIRELESS CONNECTION OF THE CONTROL BOX AND THE HEAT SOURCE